Job Description
4+ years of experience in Power electronics, analog hardware and Mixed signal HW product design and development Hands on experience in circuit design and circuit simulation (SPICE modeling), excellent skill set is a must in circuit analysis Excellent component selection and decision-making skills
Knowledge or working experience with DO 254, DO160 is an added advantage
Hands on experience in writing low level design documents, architectural design document and test procedures
Experience in using electronic components like BJT, MOSFET, GaNFET, Diodes, OP amps and PWM chips.
Experience in Thermal analysis, Load analysis and Timing analysis.
Knowledge of Signal integrity and power integrity.
Good knowledge of EMI/EMC testing procedures and Certification standards.
Familiarity with OrCAD for schematic capture, Allegro/PADS for PCB artwork design and Gerber viewers
Solid understanding of board layout fundamentals (including stack-up, power/ground planes, impedance control) and the full production process of PCB and PCBA assembly
Strong understanding of Layout techniques for EMI/EMC, Signal Integrity, crosstalk validation, Layout Designing, DRC Definition, High Speed board designing, PCB stack up finalization
Understanding of configuration management, BOM management, and document control
Use of advanced test equipment, hands on experience in design/troubleshoot/ fixing hardware.
Salary : Not Disclosed by Recruiter
Industry : Engineering Design / R&D
Functional Area : IT Software- Embedded / EDA / VLSI / ASIC / Chip Design
Role Category : Electronics Engineering
Employment Type : Full-Time